RGI Masonry & Construction, LLC handles full roofing replacements in Rio Rancho, working with shingles, metal roofing, and TPO membrane systems to address failures that have progressed past the point of a simple patch. Homeowners dealing with granule loss on aging shingles, seams lifting on flat roofs, or visible daylight through decking need more than a surface fix—they need a process that starts at the structure. A proper replacement uncovers what the existing roof has been hiding, including deteriorated plywood and frame damage that a layer-over job would simply seal in.

The replacement process at RGI Masonry & Construction begins with a complete tear-off, stripping the existing material down to the deck. Once the old roofing is removed, the frame and plywood are inspected directly—any soft spots, rot, or compromised sheathing are identified before new material goes down. This sequencing matters because in residential construction across the Rio Rancho area, many homes built during the growth periods of the 1980s and 1990s used standard OSB decking that absorbs moisture damage over time from flashing failures and failed penetration seals, often invisibly until a tear-off exposes it. New material is installed only after the substrate passes inspection.



Arrange an on-site assessment to review the current condition of your decking and determine which roofing system fits your property.

Answers About How the Work Is Done

Roofing replacements involve decisions at every phase, and the choices made during tear-off and decking inspection directly affect how long the finished roof performs. These questions address the key steps in that process.

• What happens to the old roofing material during a tear-off? All existing material is stripped from the deck and removed from the property. Nothing is layered over, which means the new installation starts on a clean, inspectable substrate rather than one that could be concealing deterioration.
• How is the plywood deck evaluated after tear-off? Each panel is walked and probed for soft spots, delamination, and areas where fastener holding strength has been compromised by long-term moisture. Panels that fail this check are replaced with new sheathing before underlayment is installed.
• Why does roof slope determine which material is used? Shingles and metal panels require minimum pitch thresholds to shed water effectively—installing them on a slope below those thresholds causes water to back up under the material at the lap joints. TPO membrane systems are engineered for low-slope applications where ponding is a realistic condition.
• What distinguishes a properly installed TPO roof from one that will fail early? The critical quality indicator is seam integrity. Heat-welded seams create a homogenous bond between panels that resists separation under thermal cycling. Taped or cold-applied seams are a shortcut that typically fails within a few years at the overlap edges.
• How do the construction characteristics of Rio Rancho homes affect roofing scope? Many single-family homes built during the rapid development of the area use wood-framed roof assemblies with OSB decking, which is more susceptible to long-term moisture damage at penetration points than older board sheathing. Tear-offs on these homes frequently reveal decking replacement needs that would not be detectable without removing the existing roof material.

RGI Masonry & Construction also provides roofing services in Albuquerque, Bernalillo, Placitas, and Santa Fe. To start with a direct evaluation of your roof's current condition and decking integrity, contact RGI Masonry & Construction to schedule an inspection and discuss which replacement system fits the structure.